VeraCrypt

Documentation >> System Encryption

System Encryption

VeraCrypt can on-the-fly encrypt a system partition or entire system drive, i.e. a partition or drive where Windows is installed and from which it boots.
System encryption provides the highest level of security and privacy, because all files, including any temporary files that Windows and applications create on the system partition (typically, without your knowledge or consent), hibernation files, swap files, etc., are always permanently encrypted (even when power supply is suddenly interrupted). Windows also records large amounts of potentially sensitive data, such as the names and locations of files you open, applications you run, etc. All such log files and registry entries are always permanently encrypted as well.
System encryption involves pre-boot authentication, which means that anyone who wants to gain access and use the encrypted system, read and write files stored on the system drive, etc., will need to enter the correct password each time before Windows boots (starts). Pre-boot authentication is handled by the VeraCrypt Boot Loader, which resides in the first track of the boot drive and on the VeraCrypt Rescue Disk (see below).
Note that VeraCrypt can encrypt an existing unencrypted system partition/drive in-place while the operating system is running (while the system is being encrypted, you can use your computer as usual without any restrictions). Likewise, a VeraCrypt-encrypted system partition/drive can be decrypted in-place while the operating system is running. You can interrupt the process of encryption or decryption anytime, leave the partition/drive partially unencrypted, restart or shut down the computer, and then resume the process, which will continue from the point it was stopped.
The mode of operation used for system encryption is XTS (see the section Modes of Operation). For further technical details of system encryption, see the section Encryption Scheme in the chapter Technical Details.
To encrypt a system partition or entire system drive, select System > Encrypt System Partition/Drive and then follow the instructions in the wizard. To decrypt a system partition/drive, select System > Permanently Decrypt System Partition/Drive.
Because of BIOS requirement, the pre-boot password is typed using US keyboard layout. During the system encryption process, VeraCrypt automatically and transparently switches the keyboard to US layout in order to ensure that the password value typed will match the one typed in pre-boot mode. However, pasting the password from the clipboard can override this protective measure. To prevent any issues arising from this discrepancy, VeraCrypt disables the option to paste passwords from the clipboard in the system encryption wizard. Thus, when setting or entering your password, it's crucial to type it manually using the same keys as when creating the system encryption, ensuring consistent access to your encrypted system.

Note: By default, Windows 7 and later boot from a special small partition. The partition contains files that are required to boot the system. Windows allows only applications that have administrator privileges to write to the partition (when the system is running). In EFI boot mode, which is the default on modern PCs, VeraCrypt can not encrypt this partition since it must remain unencrypted so that the BIOS can load the EFI bootloader from it. This in turn implies that in EFI boot mode, VeraCrypt offers only to encrypt the system partition where Windows is installed (the user can later manually encrypt other data partitions using VeraCrypt). In MBR legacy boot mode, VeraCrypt encrypts the partition only if you choose to encrypt the whole system drive (as opposed to choosing to encrypt only the partition where Windows is installed).

 

Next Section >>